Fiero L4-151 2.5L (1985)
11.
Retaining bolt (1) in left front engine mount.
12.
Place axle stand under right front suspension support, raise into position and fasten with retaining bolts (6).
13.
Place axle stand under left front suspension support, raise into position and fasten with retaining bolts.
14.
Crankshaft pulley and bolt (w/assistant).
15.
Flywheel/flexplate cover and bolts.
16.
Engine splash shield.
17.
Brakeline-to-body bracket.
18.
Right front wheel.
19.
Lower vehicle.
20.
Transaxle bracket to transaxle mount long bolt.
21.
Remove engine support fixture.
22.
Timing pointer plate (1985-86 only).
23.
Engine coolant (1985-86 only).
24.
Engine oil (replace oil filter).
25.
Power steering pump mount bolts to engine.
26.
Accessory drive belts.
27.
Front end sheet metal diagonal brace (R.H.).
28.
Body ground strap.
29.
Negative battery cable.
30.
Check front end toe and adjust if necessary.
Inspect
-
For oil and coolant leaks with engine running at operating temperature.
-
For proper completion of repairs.
Warranty Information
Labor Operation:
J0840
For 1987-88
Labor Time
:
4.7 Hours
A/C - Add
:
.2 Hour
To Replace Crankshaft Gear - Add
:
.1 Hour
Automatic Transmission (1987 only) - Add :
.1 Hour
Locking Wheel Covers and/or Nuts - Add :
.1 Hour
For 1985-86
Labor Time
:
5.1 Hours
A/C - Add
:
.2 Hour
To Replace Crankshaft Gear - Add
:
.1 Hour
Automatic Transmission - Add
: .
1 Hour
Locking Wheel Covers and/or Nuts - Add :
.1 Hour
Fiero Model Service Procedure
Tools Required:
J28467-A
Engine Support Fixture
J28467-60
Support Foot (GT Fastback Only)
J24420-B
Cam Gear Removal Tool
J25033-B
Cam Gear Installation Tool
J34065
Parking Brake Cable Retainer Compressor
J34995
Crankshaft Front Cover Oil Seal Installer
J8001
Universal Dial Indicator W/Magnetic Base