Fiero L4-151 2.5L (1985)
22.
Timing pointer plate (as applicable).
23.
Accessory drive belt(s).
24.
Engine oil (replace oil filter).
25.
Coolant.
26.
Negative battery cable.
27.
Check front end toe and adjust if necessary.
Inspect
-
For oil and coolant leaks with engine running at operating temperature.
-
For proper completion of repairs.
Warranty Information
Labor Operation:
J0840
For 1987-88
Labor Time
:
3.9 Hours
To Replace Crankshaft Gear - Add
:
.1 Hour
Locking Wheel Covers and/or Nuts - Add
:
.2 Hour
For 1982-86
Labor Time
:
4.2 Hours
A/C - Add
:
.1 Hour
To Replace Crankshaft Gear - Add
:
.1 Hour
Locking Wheel Covers and/or Nuts -
Add
:
.2
Hour
Grand AM Model Service Procedure
Tools Required:
J28467-A
Engine Support Fixture (with long hooks)
J24420-B
Cam Gear Removal Tool
J5033-B
Cam Gear Installation Tool
J34995
Crankshaft Front Cover Oil Seal Installer
J8001
Universal Dial Indicator W/Magnetic Base
Remove or Disconnect
1.
Negative battery cable.
2.
Accessory drive belts.
3.
Power steering pump mount bolts - lay pump aside.
4.
Drain coolant (1985-86 only).
5.
Timing pointer plate (1985-86 only).
6.
Body ground strap.
7.
Front end sheet metal diagonal brace (R.H.).
8.
Install engine support fixture - J28467-A per Service Manual.
9.
Upper front engine mount to body bolts (2).
10.
Raise vehicle.
11.
Right front wheel.
12.
Right front brakeline-to-body bracket.
13.
Right front wheelhouse engine splash shield.
14.
Flywheel/flexplate cover.
15.
Crankshaft pulley (have assistant hold flywheel) .
16.
Rear engine mount to bracket nuts and mount thru bolts.
17.
Rear transaxle strut - automatic transaxle only (as applicable).
18.
Lower front engine mount to body bolt (leave mount attached to engine).
19.
Retaining bolts from right side front suspension support (6).