Fiero V6-173 2.8L (1986)
FIGURE 4 - SUSPENDING CALIPER
FIGURE 5 - LUBRICATING CALIPER CAVITY
^
Plug openings in caliper and pipe to prevent fluid loss and contamination.
6.
Boots (3), mounting bolts (1), and sleeves (2) using No. 50 Torx wrench.
7.
Caliper (13) from rotor and mounting bracket (17). If only shoe and linings are being replaced, suspend with a wire hook (16) from strut.
Inspect
^
Mounting bolts and sleeves for corrosion.
^
If corrosion is found, use new parts, including bushings, when installing caliper.
^
Do not attempt to polish away corrosion.
Important
^
See NOTICE on page 5-1.
Install or Connect
1.
Liberally fill both cavities in housing (13) between bushings (4) with silicone grease.
2.
Sleeves (2) in caliper (13).
3.
Caliper (13) over rotor in mounting bracket (17).
4.
Mounting bolts (1) to 28-47 N-m (21-35 ft.lbs.).
5.
Boots (3).
^
Make sure boots are mounted securely.
v Measure
