Fiero V6-173 2.8L (1986)
FIGURE 9 - SHIFT SHAFT
9.
Prior to the installation of the detent holder cover, inspect the 1st/2nd shift shaft, it must still be the same height as the 3rd/4th and reverse shift
shafts (fig. 9). Shift the transaxle through each gear checking for proper operation. If the transaxle shifts correctly return to the neutral position and
continue to Step 11. If the shift mechanism is locked, the 1st/2nd shift shaft has slipped down during installation of the interlock plate and the shaft
must be pulled up.
10.
To pull the 1st/2nd shaft up, reinstall screwdriver in vent hole. Loosen bolt A and remove bolt B. Pull shaft up using pliers. Swing interlock plate
into position, pry detent holder assembly into place with screwdriver and loosely install bolt B. Return to Step 7.
FIGURE 1 - HOLDER COVER
11.
Tap the detent holder cover (fig. 1) into the bore until seated.