Firebird V6-3.8L VIN K (1995)
CLEAN
^
Fuel sender assembly sealing surfaces.
INSTALL OR CONNECT
NOTICE:
Fuel pump strainer must be in a horizontal position. When installing the fuel sender assembly, assure that the fuel pump strainer does not block full
travel of float arm.
1. Position new fuel sender assembly seal on fuel tank.
2. Gently fold fuel strainer over itself.
^
Slowly position fuel sender assembly in fuel tank so that the fuel strainer is not damaged or trapped by sump walls.
3. Fuel sender assembly into fuel tank.
Tighten
Fuel sender assembly retaining nuts to 6.5 Nm (58 lb. in.).
4. Fuel tank.
5. Add fuel and install fuel filler cap.
6. Negative battery cable.
INSPECT
^
Turn ignition switch to "ON" position for two seconds, then turn to "OFF" for ten seconds. Again turn to "ON" position and check for fuel leaks.
