Firebird V8-305 5.0L (1982)
2.
Start mounting bolts through sleeves in inboard caliper ears and the mounting bracket, making sure ends of bolts pass under ears on inboard shoe.
Right and left calipers must not be interchanged.
3.
Push mounting bolts through to engage holes in the outboard ears. Then thread mounting bolts into bracket.
4.
Torque mounting bolts to 28 ft. lbs.
5.
Check the dimensions between each caliper stop and caliper, Fig. 9.
6.
If brake hose was removed, reconnect it and bleed the calipers.
7.
Replace front wheels, lower vehicle and add brake fluid to master cylinder to bring level to 1/4 inch from top. Before moving vehicle, pump
brake pedal several times to be sure it is firm. Do not move vehicle until a firm pedal is obtained. On some models with low drag calipers,
apply approximately 175 pounds of pressure to the brake pedal three times to properly seat the caliper and related components.
