Firebird V8-305 5.0L (1982)
Fig. 3 Drum brake assembly. Type 3
5.
Install actuating levers, actuating link and return spring, Figs. 1, 2 and 3.
6.
Install hold-down springs with suitable tool.
7.
Install primary and secondary shoe return springs using brake spring pliers or equivalent.
8.
Using suitable brake drum to shoe gauge, measure brake drum inside diameter. Adjust brake shoes to dimension obtained on outside portion of
gauge.
9.
Install brake drum, wheel and tire assembly.
10.
If any hydraulic connections have been opened, bleed brake system.
11.
Adjust parking brake. Refer to individual car chapters for procedures.
12.
Inspect all hydraulic lines and connections for leakage and repair as necessary.
13.
Check master cylinder fluid level and replenish as necessary.
14.
Check brake pedal for proper feel and return.
15.
Lower vehicle and road test. Do not severely apply brakes immediately after installation of new brake linings or permanent damage may
occur to linings, and/or brake drums may become scored. Brakes must be used moderately during first several hundred miles of operation
to ensure proper burnishing of linings.
