Firebird V8-305 5.0L (1982)
Fuel Injector: Testing and Inspection
Kent-Moore Fuel Injector Tester, tool J-39021, has the capability of performing injector balance and coil tests on all GM and many non-GM fuel
injection systems. In addition to the familiar fuel pressure drop test, the injector coil test is a new test whereby the injector's resistance is measured during
normal operation by feeding a fixed current through the injector and measuring the voltage drop across the injector. Injector coil failures are more
accurately detected using this method than by simply measuring the injector's resistance with an ohmmeter. Refer to the instructions included
with the tool.
For further information, refer to TSB 93-6E-14, dated June 1993. (Corp. Ref. No.: 316501R)
NOTE: Measuring injector resistance is not a fool-proof method of determining the condition of the injectors. A Fuel Injector Balance Test will more
accurately determine the mechanical condition of the injector, while the injector resistance will determine the electrical condition of the injector. If
available, use applicable C-Charts at Computers and Control Systems, Testing and Inspection. You should also start at Diagnostic System Check if
you have not already done so.
See: Computers and Control Systems/Testing and Inspection
