Firebird V8-305 5.0L (1982)
Fuel Pressure: Testing and Inspection
NOTE: Before servicing fuel system components, fuel system pressure must be released.
To relieve pressure, proceed as follows:
a. Remove fuel pump fuse from fuse block.
b. Run engine until fuel remaining in lines is consumed. When engine shuts down, engage starter for approximately three seconds to relieve any
remaining pressure.
c. With ignition off, replace fuel pump fuse.
1. Remove air cleaner and plug THERMAC vacuum port on throttle body unit.
2. Remove fuel line between TBI unit and fuel filter or between front and rear TBI units on "Crossfire" injection systems. Use a suitable back-up
wrench to hold flare nut on throttle body when removing line.
3. Install fuel pressure gauge J-29658 or equivalent, between throttle body and filter or, on "Crossfire" systems, between front and rear TBI units.
4. Check pressure reading with engine running. If fuel pressure is not between 9 and 13 psi, refer to "Fuel System Diagnosis."
5. De-pressurize fuel system, remove pressure gauge and reinstall fuel line.
6. Start engine and check for fuel leaks.
7. Remove plug from THERMAC vacuum port and install air cleaner.
