Firebird V8-305 5.0L (1982)
f.
Install the wear plate (#640) on top of the brass end cap. Place the overrun clutch hub (#639) on the wear plate; (#640) engage the tangs;
and, insert the snap ring (#638) to retain it.
Figure 4
g.
Now, check for proper assembly as shown in Figure 4.
2.
Some of the parts associated with the roller clutch are similar in appearance to the sprag clutch parts.. If these parts are ever mixed, use the
following information to identify which parts are roller design and which parts are sprag design. (First design refers to roller clutch parts and
second design refers to sprag clutch parts.)
Figure 5
a.
Overrun Clutch Hub (#639) - See Figure 5. First Design - Face of tangs was flat.
Second Design - High spot on each tang.
Figure 6
b.
Outer Race Forward Clutch (#644) - See Figure 6 First Design - Lube hole in race. Second Design - Lube hole in shoulder.
