Firebird V8-5.7L VIN G (2001)
Cruise Control Servo Cable: Adjustments
Cruise Control Cable Adjustment (Without RPO NW9)
1. Ensure that the cable fitting is snapped onto the throttle lever pin.
2. Ensure that the cable is locked into position on the bracket.
3. Pull the cable adjustment slider on the cable end rearward until all slack is removed from the cable but without opening the throttle.
4. Push down cable adjustment lock button until it snaps and locks in place.
5. Ensure that the locking tab is secure on both sides.
IMPORTANT: Cable must not have more than 2.0 mm (0.078 in) of slack.
6. Excess slack in cable can cause poor performance, such as hesitation on cruise setting. Important: Cable should never be adjusted so tightly that
tension from the cable will not allow the throttle to close properly.
7. Pulling cable too tight will prevent engine from returning to idle and could cause unstable idle quality.
"For a description of the RPO Code(s) Shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application and
ID." See: Application and ID/RPO Codes
