G5 L4-2.2L (2007)
2. Install the accelerator pedal and sensor assembly mounting bolts.
Tighten the bolts to 9 N.m (80 lb in).
3. Install the brake pedal assembly, with the accelerator pedal assembly to the vehicle.
4. Install the cruise control release switch, if equipped, to the pedal bracket.
5. Install the stop lamp switch to the pedal bracket.
6. Move the brake pedal assembly to the installed position.
7. Install the brake pedal bracket-to-steering column bracket bolt (1).
Tighten the bolt to 25 N.m (18 lb ft).
8. Loosely install the brake booster mounting nuts.
9. Apply a thin coat of high temperature grease GM P/N 12345994 (Canadian P/N 10953501) to the pushrod pin on the brake pedal.
10. Connect the brake booster pushrod (2) to the brake pedal.
11. Install the washer (3) and retaining clip (4) to the brake pedal.
12. Tighten the vacuum brake booster mounting nuts.
Tighten the nuts to 17 N.m (14 lb ft).
13. Adjust the stop lamp switch. Refer to Stop Lamp Switch Adjustment.
14. Adjust the cruise control release switch, if equipped. Refer to Cruise Release Switch Adjustment.
