G6 L4-2.4L (2007)
Wheel Fastener: Service and Repair
Rear Suspension
Wheel Stud Replacement
Tools Required
J 43631 Ball Joint Separator
Removal Procedure
1. Raise the vehicle on a hoist. Refer to Vehicle Lifting.
2. Remove the tire and wheel assembly.
3. Remove the brake rotor.
4. Using the J 43631, release the wheel stud from the bearing hub and discard the stud.
Installation Procedure
1. Install a NEW stud into the bearing/hub assembly. Add enough washers (3) in order to draw the stud into the hub.
2. Install and tighten a wheel nut (1) until the head of the wheel stud is fully seated against the back of the bearing/hub flange.
3. Remove the wheel nut (1) and the washers (3).
4. Install the brake rotor.
5. Install the tire and wheel assembly.
6. Lower the vehicle.
