G6 V6-3.5L VIN 8 (2005)
2.
Install the air temperature actuator.
Note:
Refer to Fastener Notice in Cautions and Notices.
3.
Install the air temperature actuator screws.
Tighten
Tighten the screws to 1.5 N.m (13 lb in).
4.
Close the I/P compartment door.
5.
Install the fuse labeled HVAC CTRL (BATT).
Mode Actuator Replacement
Removal Procedure
1.
Remove the fuse labeled HVAC CTRL (BATT).
2.
Remove the left closeout panel.
3.
Remove the knee bolster. Refer to Knee Bolster Replacement.
4.
Remove the mode actuator retaining screws.
5.
Remove the mode actuator.
6.
Disconnect the mode actuator electrical connector.
Installation Procedure