G6 V6-3.6L (2007)
Install the brake and accelerator pedal adjustment position sensor (2) to the brake pedal bracket. Ensure the brake pedal position sensor tab locks
into the brake pedal bracket and the sensors arm is correctly installed.
2. NOTE: Refer to Fastener Notice.
Install the brake pedal adjustment position sensor bolt (1).
Tighten the bolt to 2 N.m (18 lb in).
3. Install the electrical connector to the brake and accelerator pedal adjustment position sensor.
4. Install the steering wheel stub shaft to the steering column.
5. Install the closeout panel.
Brake Pedal Position Sensor Replacement
BRAKE PEDAL POSITION SENSOR REPLACEMENT
REMOVAL PROCEDURE
1. Remove the closeout panel.
2. Remove the steering wheel stub shaft bolt and position the steering wheel stub shaft away from the steering column in order to gain access to the
brake pedal adjustment position sensor.
3. Remove the electrical connector from the brake pedal position sensor.