G6 V6-3.6L (2007)
1. After the Initialization Procedure is complete, release the sunshade switch. Activate the close and release the sunshade switch 2 successive times.
2. Hold the switch in the active close position.
3. The window and the sunshade will travel to the full open position and then stall or hard stop approximately 1 second, then return to the full
closed position. This is also known as the soft stop position.
4. Hold the switch for approximately 2 seconds. The profile data is saved to the EEPROM.
IMPORTANT: The Teach Procedure is not complete if one of the following occurs before the cycle has finished:
-
The rotary switch is moved from the closed position.
-
The sunshade switch is not held continuously in the activate close position.
-
Ignition and/or battery power have been removed.
-
The window and/or the sunshade have not reached the full soft stop close position after opening.
IMPORTANT: If the Teach Procedure is not carried out completely, only part of the profile data will be stored, and the Teach Procedure must be
started again.
IMPORTANT:
-
If the ignition is inactive, neither the window lamella nor the sunshade can be moved by the rotary switch.
-
If the ignition is inactive, the sunshade cannot be moved by the sunshade switch.
-
If the ignition goes inactive during window or sunshade movement after the Initialization or Teach Procedure, the window lamella and/or sunshade
will stop.
