G6 V6-3.6L (2007)
1. Position the sunroof motor to the sunroof module.
2. Push the sunroof motor straight upward to engage the drive gear between the cables housed within the sunroof cable drive tubes.
3. NOTE: Refer to Fastener Notice.
Install the sunroof actuator screws to the sunroof actuator.
Tighten the screws to 4 N.m (35 lb in).
4. Connect the electrical connector to the sunroof motor.
5. Install the headliner.
6. Initialize/teach the sunroof motor. Refer to Control Module References for programming and setup information. See: Testing and
Inspection/Programming and Relearning
7. Inspect the sunroof for proper operation.
Sunroof Motor/Actuator Replacement (With RPO Code C3Y)