G6 V6-3.6L (2007)
6. Remove the master cylinder, ensure the master cylinder-to-vacuum brake booster seal for damage. Replace seal if necessary.
7. Remove the reservoir from the master cylinder if it is to be reused on a replacement master cylinder.
Installation Procedure
1. Install the brake master cylinder reservoir to the master cylinder if it was removed previously.
2. Bench bleed the master cylinder. Refer to Master Cylinder Bench Bleeding .
3. Check to ensure that the master cylinder-to-vacuum brake booster seal is properly seated on the master cylinder barrel.
4. Install the master cylinder to the vacuum brake booster.
Notice: Refer to Fastener Notice .
5. Install the 2 brake master cylinder mounting nuts.
Tighten the 2 brake master cylinder mounting nuts to 25 N.m (18 lb ft).
6. Remove the plugs from the brake pipes.
7. Install the brake pipes to the master cylinder.
Tighten the brake pipe fittings at the master cylinder to 20 N.m (15 lb ft).
8. Connect the electrical connector to the brake fluid level sensor.