pontiac Workshop Repair Guides

Pontiac Workshop Service and Repair Manuals

Fuel Gauge > < Driver/Vehicle Information Display|Description and Operation
Page 2
background image

TRIP A and TRIP B

The radio determines vehicle trip odometer mileage based on the vehicle speed signal (VSS) from the body control module (BCM). The trip odometer
displays accumulated km (mi) since the last reset of this value. The trip odometer is capable of displaying up to 999.9 km (999.9 mi). Trip odometer
information is not retained when the battery is disconnected. Press and hold the ENTER button on the radio for one second in order to reset the trip
odometer display.

MENU

The MENU button is used in order to navigate through the following personalization modes:

*

AUTO UNLK

*

DELAY LOCK

*

EXT LIGHTS

*

LANGUAGE

*

LIGHT FLASH

*

LOCK HORN

*

OIL-LIFE RESET

*

REMOTE START

*

SECURITY

*

UNITS

*

UNLOCK HORN

OIL-LIFE RESET

The powertrain control module (PCM) or the engine control module (ECM) sends the oil life remaining percentage to the body control module (BCM)
via a serial data message. The radio receives a serial data message from the BCM indicating the remaining oil life. The radio displays the current
percentage of the GM Oil Life System as determined by the PCM/ECM. When the oil life remaining percentage drops below 10 percent, the radio
displays CHANGE ENGINE OIL. When the engine oil is changed, reset the engine oil life in order to clear the oil life remaining percentage display.
Press and hold the ENTER button for 5 seconds until the radio displays ACKNOWLEDGED.

For more information on the rest of the personalization modes, refer to Owner Manual.

Outside Air Temperature

The body control module (BCM) reads the outside air temperature sensor. The temperature sensor is a 2-wire negative temperature co-efficient
thermistor. The BCM provides 5 volts to an internal input resistor that is connected to the outside air temperature sensor. The outside air temperature is
displayed in the driver information center (DIC) and the DIC is located in the radio. The temperature information is transmitted by the BCM for display
in the DIC via GMLAN serial data message. The BCM provides the outside air temperature information in Celsius. The radio converts the temperature
to Fahrenheit, if required.

Indicators and Warning Messages

For more information on driver information center (DIC) warning messages, refer to Indicator/Warning Message Description and Operation.

Fuel Gauge > < Driver/Vehicle Information Display|Description and Operation