G6 V6-3.6L (2007)
11. Install the brake pipes to the clips.
12. Install the brake, fuel, and EVAP pipe clips (1, 2) to the studs on the front of dash.
13. Remove the caps from the fuel rail pipe and the EVAP purge solenoid.
14. Connect the EVAP pipe (3) quick connect fitting to the EVAP purge solenoid.
15. Connect the fuel feed pipe (1) quick connect fitting to the fuel rail.
16. Install the fuel feed pipe clip nut (2) to the intake manifold stud.
Tighten the nut to 10 N.m (89 lb in).
17. Install the fuel injector sight shield.
18. Connect the negative battery cable.
19. Tighten the fuel fill cap.
20. Inspect for leaks.
1. Turn ON the ignition, with the engine OFF for 10 seconds.
2. Turn OFF the ignition for 10 seconds.