G6 V6-3.6L (2007)
Rezero the PPS. Refer to Passenger Presence System Rezeroing in SI.
Check for DTC 056.
If flash DTC 056 is set and the cushion is NOT wet, follow the normal diagnostics for this flash DTC. Refer to DTC 056 in SI.
If flash DTC 056 is set and the cushion is wet:
Remove the cushion cover. Allow the cushion to dry for 48 hours (use a fan to assist the drying process). Refer to Front Seat Cushion Cover
Replacement in SI.
After the cushion has dried, clear the DTC.
Use the Tech 2(R) scan tool to re-check for codes.
If the code does not return, the issue has been corrected. DO NOT replace the cushion and module.
If replacement of the PPS cushion sensor and module assembly is required, these parts will be sent in a set (cushion and module) and must be replaced as
a set, since they are calibrated at the manufacturer as a set.
ONLY replace the PPS cushion and module assembly if the DTC returns after the cushion is thoroughly dry.
Warranty Information
For vehicles repaired under warranty, use the table.
Disclaimer
