G6 V6-3.6L (2007)
Notice: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation
easier. Failure to follow these procedures could result in component damage.
Notice: Refer to Fastener Notice.
4. Install the inlet pipe to the power steering gear and install the retaining bolt.
Tighten the power steering gear inlet/outlet pipe retaining bolt to 27 N.m (20 lb ft).
5. Connect the power steering gear inlet pipe/hose fitting to the power steering pump.
Tighten the power steering gear inlet pipe/hose fitting to 27 N.m (20 lb ft).
6. Install the RH front tire and wheel.
7. Lower the vehicle.
8. Fill and bleed the power steering system. Refer to Power Steering System Bleeding.