G6 V6-3.6L (2007)
11. Remove the 3 transaxle bracket to cradle/frame nuts.
12. Position the transaxle bracket and rear mount aside.
13. Remove the bolt and disconnect the power steering gear inlet and outlet pipe/hoses from the power steering gear. Cap off the pipe/hoses and
position aside.
14. Remove the power steering gear mounting bolts, nuts, and washers from the gear.
Important: The power steering gear will need to be rotated while it is removed through the LH wheel opening.
15. Remove the power steering gear through the LH wheel opening.
16. If the power steering gear is to be replaced, transfer the outer tie rod ends to the new steering gear.
Installation Procedure
Important: The power steering gear will need to be rotated while it is installed through the LH wheel opening.
1. Position the power steering gear into the vehicle.