G6 V6-3.6L (2007)
Steering Shaft: Service and Repair
Intermediate Steering Shaft Replacement
Removal Procedure
Important: The steering column lever MUST be in the LOCK (FULL UP) position before disconnecting the following components:
^
The steering column
^
The intermediate steering shaft
Notice: Secure the steering wheel utilizing a strap to prevent rotation. Locking of the steering column will prevent damage and a possible
malfunction of the SIR system. The steering wheel must be secured in position before disconnecting the following components:
-
The steering column
-
The intermediate shaft
-
The steering gear
After disconnecting these components, do not move the front tires and wheels. Failure to follow these procedures may cause improper alignment
of some components during installation and result in possible damage to the SIR coil.
Turn the steering wheel to the straight forward position, support it from movement.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the left front tire.
3. Remove the intermediate shaft to steering gear pinch bolt. Discard the bolt.
4. Disconnect the intermediate shaft from the steering gear.
5. Lower the vehicle.