G6 V6-3.6L (2007)
10. Adjust the jackstand to lower the rear of the frame.
11. Position a drain pan under the forward servo cover.
12. Remove the servo cover bolts.
13. Remove the forward servo cover.
14. Remove the forward servo cover O-ring.
15. Remove the servo piston assembly.
16. Remove the servo spring.
Installation Procedure
1. Install the servo spring.
2. Install the piston assembly.
3. Install the O-ring.
4. Install the servo cover.
Notice: Refer to Fastener Notice.
5. Install the forward servo cover bolts.
Tighten the bolts to 12 N.m (106 lb in).
6. Remove the drain pan from under the forward servo cover.
7. Adjust the jackstand to raise the rear of the frame.
8. Install the frame bolts.
9. Remove the support from the rear of the frame.
10. Install the power steering lines to the right side of the frame.
11. Install the engine mount lower nuts.
12. Install the rear transaxle mount bracket lower nuts.
13. Install the transaxle mount lower nuts.
Important: It is recommended that the transmission adaptive pressure (TAP) information be reset. Resetting the TAP values using a scan
tool will erase all learned values in all cells. As a result, the engine control module (ECM), powertrain control module (PCM) or
transmission control module (TCM) will need to relearn the TAP values. Transmission performance may be affected as new TAP values
are learned. Reset the TAP values. Refer to Transmission Adaptive Functions.
14. Install the power steering gear.
15. Lower the vehicle.
16. Remove the engine support fixture.