G6 V6-3.6L (2007)
Tools Required
^
J 41227 Output Shaft Sleeve Remover
^
J 41228 Output Shaft Sleeve Installer
^
J 41102-1A Axle Seal Installer
Removal Procedure
1. Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the drive axle assembly.
3. Use a medium screwdriver and a mallet in order to remove the case cover seal.
4. Remove the drive axle retaining clip from the output axle.
5. Use the J 41227 in order to remove the sleeve from the output axle shaft.
6. Clean and inspect the seal bore.
7. Use fine sand paper in order to remove any burrs or nicks. Clean the entire area after any sanding.
Installation Procedure
