G6 V6-3.6L (2007)
2. Install the filter (100).
3. Install the gasket (25) and the oil pan (24).
Front Wheel Drive Shaft Oil Seal Replacement - Left
Front Wheel Drive Shaft Oil Seal Replacement - Left Side
Tools Required
^
J 23129 Universal Seal Remover
^
J 6125-1B Slide Hammer Adapter
^
J 6125-B Slide Hammer
^
J 34115 Sprocket Bearing Installer
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the left front tire and wheel.
3. Remove the left stabilizer shaft link from the left lower control arm.
4. Remove the left tie rod end from the left steering knuckle.
5. Remove the left lower ball joint from the left steering knuckle.
6. Disconnect the left drive axle from the transaxle.
7. Secure the left drive axle to the left steering knuckle and strut.
8. Use the J 6125-B, J 6125-1B, and the J 23129 to remove the seal (409).
Installation Procedure