G6 V6-3.6L (2007)
3. Use J 29130 to install the new seal (4).
4. Remove the J 37292-B.
Important: Carefully guide the axle shaft past the lip seal. Do NOT allow the shaft splines to contact any portion of the seal lip surface.
5. Install the drive axle to the transaxle. Refer to Wheel Drive Shaft Replacement.
6. Install the right lower ball joint to the right steering knuckle.
7. Install the right tie rod end to the right steering knuckle.
8. Install the right stabilizer shaft link to the right steering knuckle.
9. Install the right front tire and wheel.
10. Lower the vehicle.
Notice: Refer to Transmission Overfill Notice.
11. Check and fill the transaxle fluid as necessary.
12. Inspect for fluid leaks.