G6 V6-3.6L (2007)
Disassembly/Assembly Procedure
For step by step instructions on how to disassemble/assemble the control valve body, refer to Control Valve Body Disassemble and Control Valve Body
Assemble in the Transmission Unit Repair Manual.
Installation Procedure
1. Make sure the checkballs are in the proper locations on the channel plate. Retain the checkballs with petroleum jelly.
2. Install a new spacer plate-to-channel plate gasket onto the channel plate.
3. Install the spacer plate with the spacer plate filter attached.
Notice: Refer to Fastener Notice.
4. Hand start the spacer plate support bolts and install the spacer plate support.
Tighten the spacer plate support bolts to 14 N.m (10 lb ft).
