G6 V6-3.6L (2007)
17. Remove the inner race (1) from the cage (2) by rotating the inner race (1) upward.
18. Clean the following items thoroughly with cleaning solvent. Remove all traces of old grease and any contaminates.
-
The inner and outer race assemblies
-
The CV joint cage
-
The chrome alloy balls
19. Dry all the parts.
20. Check the CV joint assembly for the following items:
-
Unusual wear
-
Cracks
-
Damage
21. Replace any damaged parts.
22. Clean the halfshaft bar. Use a wire brush to remove any rust in the seal mounting area (grooves).
Installation Procedure
Important: Place a towel in the vise before inserting the halfshaft.
1. Mount the halfshaft into a vise.
2. Install the new small eared clamp (2) on the neck of the outboard seal (1). Do not crimp.