G6 V6-3.9L (2009)
6. Remove the retractable hydraulic compartment lid cylinder (2) from the module (1).
7. Using a suitable tool, remove the ball socket ends from the assembly:
1. Release the hydraulic pump pressure. Refer to Folding Top Pump Bypass Valve Pressure Release Adjustment (See: Convertible Top
Pump/Adjustments).
2. Use a small flat-bladed tool to lift the retainer spring flex clip.
3. Do not reuse spring flex clip. Replace spring flex clip after disassembly.
4. Before disconnecting the cylinder hoses, have the replacement cylinder ready.
5. Once the cylinder hose or the port plug has been removed, DO NOT move the cylinder rod. This will cause fluid to squirt out of the ports.
8. Remove the hydraulic compartment lid cylinder from the vehicle.
Installation Procedure
1. Install the hydraulic compartment lid cylinders to the vehicle.
2. Connect the hydraulic lines to the retractable hydraulic compartment lid cylinders:
1. Install new O-rings to the cylinder hoses.
2. Install the hoses into the cylinder ports. Press down on the hoses until the hoses are fully seated into the cylinder.
3. Install new cylinder hose flex clips.
4. Inspect the flex clips to ensure that the clips are fully seated around the hoses.