G6 V6-3.9L (2009)
39. Install the manifold plate bolts (1).
Tighten the bolts to 10 Nm (89 lb in).
Note:
*
If you are replacing hose sets for more than one cylinder, complete the procedure for one cylinder before you begin with another.
*
If replacing any of the pump side quick release hoses, hydraulic cylinder removal is not necessary.
40. Remove the hydraulic cylinder from the mounting location. Do NOT remove the hoses from the cylinder at this time. Refer to the following
procedures:
*
Folding Top Header Latch Hydraulic Cylinder Replacement (See: Convertible Top Hydraulic Cylinder/Service and Repair/Removal and
Replacement/Folding Top Header Latch Hydraulic Cylinder Replacement)
*
Folding Top Side Rail Link Cylinder Replacement - Main Rail (See: Convertible Top Hydraulic Cylinder/Service and Repair/Removal and
Replacement/Folding Top Side Rail Link Cylinder Replacement - Main Rail)
*
Roof Retractable Panel Stowage Compartment Lid Cylinder Replacement - Upper (See: Convertible Top Deck Lid Components/Convertible
Top Deck Lid/Service and Repair/Removal and Replacement/Roof Retractable Panel Stowage Compartment Lid Cylinder Replacement -
Upper)
*
Roof Retractable Panel Stowage Compartment Lid Cylinder Replacement - Rear (See: Convertible Top Deck Lid Components/Convertible
Top Deck Lid/Service and Repair/Removal and Replacement/Roof Retractable Panel Stowage Compartment Lid Cylinder Replacement - Rear
)
*
Roof Retractable Panel Stowage Compartment Lid Cylinder Replacement - Rear Lower (See: Convertible Top Deck Lid
Components/Convertible Top Deck Lid/Service and Repair/Removal and Replacement/Roof Retractable Panel Stowage Compartment Lid
Cylinder Replacement - Rear Lower)
Note: Improper hose routing can lead to hose failure as a result of rubbing or pinching.
41. Route the new hose set to the cylinder in the same way as the set being replaced.
Note: Remove only one fastener at a time so that the amount of slack between fasteners can be exactly duplicated between the hose sets.
42. Depending on the hose set, you may have to remove and replace the following components:
*
The tie wraps
*
The P-clips
*
The wire loom
*
The conduit
