G6 V6-3.9L (2009)
1. Using the J 42450-A , thoroughly clean any rust or corrosion from the mating surface of the hub/axle flange.
2. Using the J 41013 , thoroughly clean any rust or corrosion from the mating surface and mounting surface of the brake rotor.
3. Inspect the mating surfaces of the hub/axle flange and the rotor to ensure that there are no foreign particles or debris remaining.
4. Install the brake rotor to the hub/axle flange. Use the matchmark made prior to removal for proper orientation to the flange.
5. If the brake rotor was removed and installed as part of a brake system repair, measure the assembled LRO of the brake rotor to ensure optimum
performance of the disc brakes. Refer to Brake Rotor Assembled Lateral Runout Measurement (See: Testing and Inspection/Brake Rotor
Assembled Lateral Runout Measurement).
6. If the brake rotor assembled LRO measurement exceeds the specification, bring the LRO to within specifications. Refer to Brake Rotor Assembled
Lateral Runout Correction (See: Testing and Inspection/Brake Rotor Assembled Lateral Runout Correction).
7. Install the brake caliper mounting bracket an caliper as an assembly to the suspension knuckle. Refer to Rear Brake Caliper Bracket Replacement
(See: Brake Caliper/Service and Repair/Removal and Replacement/Rear Brake Caliper Bracket Replacement).
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
9. Lower the vehicle.
10. If the brake rotor was refinished or replaced, or if new brake pads were installed, burnish the pads and rotors. Refer to Brake Pad and Rotor
Burnishing (See: Brake Pad/Service and Repair/Brake Pad and Rotor Burnishing).