G6 V6-3.9L (2009)
6. Remove the recirculation door actuator.
7. Remove the recirculation door actuator wire harness connector.
Installation Procedure
1. Install the recirculation door actuator wire harness connector.
2. Install the recirculation door actuator.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Tighten the recirculation door actuator screws.
Tighten the screws to 1.5 Nm (13 lb in).
4. If equipped, install the OnStar module bracket. Refer to Communication Interface Module Bracket Replacement (See: Accessories and Optional
Equipment/Cellular Phone/Communications Control Module/Service and Repair/Communication Interface Module Bracket Replacement).