G6 V6-3.9L (2009)
1. Ensure that the steering wheel is set in a straight ahead position.
2. Loosen the tie rod jam nut (5).
3. Adjust the toe to specification by turning the adjuster (6). Refer to Wheel Alignment Specifications (See: Specifications).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Tighten the tie rod jam nut (5).
Tighten the tie rod jam nut (5) to 68 Nm (50 lb ft).
Rear Camber Adjustment
Rear Camber Adjustment
1. Loosen the inner lower control arm cam bolt nuts.
2. Rotate the cam bolts to the required camber specification setting. Refer to Wheel Alignment Measurement (See: Wheel Alignment Measurement
).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Maintain the camber setting while tightening the cam bolt nuts.
Tighten the inner lower control arm (front) bolt nut to 110 Nm (81 lb ft).
Important: Check the toe setting AFTER changing camber or caster.
4. Check the camber setting after tightening.
5. Adjust the camber setting if necessary.