G6 V6-3.9L (2009)
Fuel Line Coupler: Service and Repair
Plastic Collar Quick Connect Fitting Service
Plastic Collar Quick Connect Fitting Service
Removal Procedure
1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief (Without CH 48027) (See: Fuel Filter/Fuel Pressure Release/Service and
Repair/Fuel Pressure Relief (Without CH 48027))Fuel Pressure Relief (With CH 48027) (See: Fuel Filter/Fuel Pressure Release/Service and
Repair/Fuel Pressure Relief (With CH 48027)).
Warning
Wear safety glasses when using compressed air in order to prevent eye injury.
2. Blow dirt out of the fitting using compressed air.
3. Squeeze the plastic tabs of the male end connector.
Quick Connect Fittings
4. Pull the connection apart.
Caution: Use an emery cloth in order to remove rust or burrs from the fuel pipe. Use a radial motion with the fuel pipe end in order to prevent
damage to the O-ring sealing surface.
5. Wipe off the male pipe end using a clean shop towel.
6. Inspect both ends of the fitting for dirt and burrs.
7. Clean or replace the components as required.
Installation Procedure
Warning
In order to reduce the risk of fire and personal injury, before connecting fuel pipe fittings, always apply a few drops of clean engine oil to the male pipe
ends.
