G6 V6-3.9L (2009)
Knock Sensor: Service and Repair
Knock Sensor Replacement - Bank 2
Knock Sensor Replacement - Bank 2
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Disconnect the knock sensor electrical connector (2).
3. Loosen and remove the knock sensor (2).
Installation Procedure
Note: DO NOT apply thread sealant to the sensor threads. The sensor threads are coated at the factory. Applying additional sealant affects the sensors
ability to detect detonation.