G6 V6-3.9L (2009)
2. Install the HVAC control module.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Tighten the HVAC control module screws.
Tighten the screws to 2.5 Nm (22 lb in).
4. Install the I/P center trim panel. Refer to Instrument Panel Center Trim Panel Replacement (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair).
Note: Do not adjust any controls on the HVAC control module while the HVAC control module is calibrating. If interrupted improper HVAC
performance will result.
5. Start the engine and let run for one minute.
6. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) for programming and setup information.
