G6 V6-3.9L (2009)
Steering Gear: Service and Repair
Steering Gear Replacement (Hydraulic Power Steering)
Steering Gear Replacement (Hydraulic Power Steering LZ4, LZ9) (3.5L, 3.9L)
Special Tools
J 24319-B Universal Steering Linkage and Tie Rod Puller
Removal Procedure
1. Turn the steering wheel to the straight forward position, support it from movement, and remove the key from the ignition.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Wheels and Tires/Vehicle Lifting/Service and Repair).
3. Remove the front tires and wheels. Refer to Tire and Wheel Removal and Installation (See: Wheels and Tires/Service and Repair).
4. Remove the tie rod end castle nuts.
Caution: Do not free the ball stud by using a pickle fork or a wedge-type tool. Damage to the seal or bushing may result.
5. Using the J 24319-B , separate the tie rod ends from the steering knuckles.
6. Remove the intermediate shaft to steering gear pinch bolt (1). Discard the bolt.
Note: Secure the steering wheel in the straight forward position before separating the intermediate shaft from the steering gear, or damage to the
SIR coil will occur.
7. Separate the intermediate shaft (2) from the steering gear (3).