G6 V6-3.9L VIN 1 (2006)
Marker Lamp Bulb: Service and Repair
Headlamp Assembly or Headlamp Bulb and/or Cornering, Sidemarker, Park, Turn Signal Bulb
Replacement
HEADLAMP ASSEMBLY OR HEADLAMP BULB AND/OR CORNERING, SIDEMARKER, PARK, TURN SIGNAL BULB
REPLACEMENT
REMOVAL PROCEDURE
1. Open the hood.
CAUTION: Halogen bulbs contain gas under pressure. Handling a bulb improperly could cause it to shatter into flying glass fragments To
help avoid personal injury:
-
Turn off the lamp switch and allow the bulb to cool before changing the bulb.
-
Leave the lamp switch OFF until the bulb change is complete.
-
Always wear eye protection when changing a halogen bulb.
-
Handle the bulb only by its base. Avoid touching the glass.
-
Keep dirt and moisture off the bulb.
-
Properly dispose of the used bulb.
-
Keep halogen bulbs out of the reach of children.
2. Remove the bolts from the headlamp assembly.
IMPORTANT: Hold the headlamp to prevent damage to the headlamp or to the fascia.
3. Remove the push-in-retainers across the front fascia.
4. Remove the headlamp assembly.Lift the headlamp upward to release the locating tab from the front edge of the fender.