G8 V6-3.6L (2008)
Next Available Slot
The remote keyless entry (RKE) transmitter key pad must be programmed to the remote control door lock receiver (RCDLR) module. This
procedure will program keyless entry transmitters in sequential order. If two transmitters are currently programmed to the vehicle as transmitters 1
and 2, using this procedure will program the next transmitter as 3 and so on.
Note:
Do not operate or program the transmitters in the vicinity of other vehicles that are in the keyless entry mode. This prevents the programming
of the transmitters to the incorrect vehicle.
1.
With a scan tool, access Body/Auto HVAC or Manual HVAC. Continue to navigate through the OnStar® selections, as equipped, to Body/Remote
Control Door Lock Receiver/Module Setup menu. Select Program Key Fobs.
2.
Select Next Available Slot. The vehicle chime will sound two times to indicate that the programming mode has been entered. Fully read and then
follow the on‐screen instructions. After each transmitter has been programmed, the vehicle chime will sound to confirm the programming.
3.
When all of the desired transmitters have been programmed, cycle the ignition from ON to OFF, exit the vehicle and operate the transmitter
functions in order to verify correct system operation.
Invalidate All Fobs
This procedure will first erase all known keyless entry transmitters. After all transmitters are erased, the procedure will begin to program keyless
entry transmitters in sequential order, beginning with transmitter 1.
1.
With a scan tool, access Body/Auto HVAC or Manual HVAC. Continue to navigate through the OnStar® selections, as equipped, to Body/Remote
Control Door Lock Receiver/Module Setup menu. Select Program Key Fobs.
2.
Select Invalidate All Fobs. This will erase all known transmitters and prepare the RCDLR to program new transmitters. Fully read and then follow
the on‐screen instructions. After each transmitter has been programmed, the vehicle chime will sound to confirm the programming.
3.
When all of the desired transmitters have been programmed, cycle the ignition from ON to OFF, exit the vehicle and operate the transmitter
functions in order to verify correct system operation.
Transmitter Slot Programming - SPO Accessory Advance 2‐Way Remote Start System Only
Transmitter slot programming allows a single transmitter to be programmed into a specific slot without affecting any of the other programmed
transmitters. By using slot programming, the transmitter originally programmed to a specific slot is erased and the new transmitter learned in its
place.
Note:
The keyless entry transmitter used in the Advance 2‐Way Remote Start System is unique to the system. Attempting to replace an
Advance 2‐Way Remote Start transmitter with a regular service part may result in a failure to program the transmitter.
1.
With a scan tool, access Body/Auto HVAC or Manual HVAC. Continue to navigate through the OnStar® selections, as equipped, to Body/Remote
Control Door Lock Receiver/Module Setup menu. Select Program Key Fobs.
2.
Select the key fob desired to be programmed. The vehicle chime will sound two times to indicate that the programming mode has been entered.
Fully read and then follow the on‐screen instructions. After each transmitter has been programmed, the vehicle chime will sound to
confirm the programming.
3.
When the programming is complete, cycle the ignition from ON to OFF, exit the vehicle and operate the transmitter functions in order to verify
correct system operation.
Disclaimer