G8 V6-3.6L (2008)
Important: DO NOT re use the removed fluid.
*
If the brake fluid level is higher than midway between the maximum fill level and the minimum allowable level, syphon the brake fluid to the
midway point using a hand vacuum pump (2) before proceeding.
2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
3. Remove rear wheels. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair) .
4. Install two wheel nuts (3) in reverse to opposite wheel studs to retain the brake disc to the hub.
Important: Position the ends of the G-clamp against the rear of the brake caliper (1) and against the outboard brake pad (2).
5. Install a large G-clamp over the body of the brake caliper (1).
6. Tighten the G-clamp until the brake caliper piston bottoms out in the brake caliper bore.
7. Remove the G-clamp from the brake caliper (1).