G8 V6-3.6L (2008)
7. Disconnect brake lines (3) from the master cylinder (1), then remove master cylinder reservoir cap (2).
8. Allow the master cylinder (1) to drain into the container until empty.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
9. Install the brake lines (3) to master cylinder (1).
Tighten the brake pipe fitting to 15 Nm (11 lb ft).
Caution: Refer to Safety Glasses Caution (See: Service Precautions/Technician Safety Information/Safety Glasses Warning) .
Caution: Refer to Vehicle Lifting Caution (See: Maintenance/Vehicle Lifting/Service Precautions) .
10. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair) .
11. Remove all the wheels. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair) .