G8 V6-3.6L (2008)
15. Hand tighten the EN-48313.
Important: DO NOT allow the body of the EN-48313 to rotate when tightening the T-handle.
16. Use an open-end wench on the hex cast into the body of the EN-48313 and hand tighten the T-handle.
17. Use an open-end wrench on the hex cast of the left side intake and exhaust camshafts and rotate the camshafts towards each other in order create
slack in the chain between the actuators.
18. The EN-48313 is now correctly installed to hold the timing chain in position.
Important: Make sure that the camshaft timing chain and the camshaft position actuators are marked for correct assembly.
19. Mark the timing chain and the camshaft position actuators.
20. Remove the left side intake camshaft position actuator to camshaft retaining bolt (1).
21. Remove the left side intake camshaft position actuator (2).
Installation Procedure
