G8 V6-3.6L (2008)
11. Tighten the right catalytic converter to exhaust manifold retaining nuts (1).
Tighten the nuts to 45 N.m (33 lb ft).
12. Make sure the exhaust system is clear of all other components and chassis. If the exhaust system is not clear of all the other components loosen all
retaining nuts and re-align. Refer to Exhaust System Alignment (LY7 and L98 Engines) (See: Service and Repair/Exhaust System Alignment) .
13. Connect the battery ground cable to the battery. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and
Charging/Battery/Battery Cable/Service and Repair) .
14. If re-programming is required. Refer to Control Module References (See: Testing and Inspection/Programming and Relearning) .
15. Perform diagnostic system check using diagnostic scan tool, clear all relative DTCs and inspect system for correct operation.
