G8 V6-3.6L (2008)
1. Install the blower motor control processor (3) to the HVAC module assembly (2).
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
2. Install the blower motor control processor to HVAC module assembly retaining screws (4).
Tighten the screw to 1 N.m (9 lb in).
3. Connect the blower motor control processor electrical connector (1).
4. Install the right side floor air outlet duct. Refer to Floor Air Outlet Duct Replacement - Right Side (See: Air Duct/Service and Repair/Floor Air
Outlet Duct Replacement - Right Side) .
5. Install the close out panel. Refer to Instrument Panel Insulator Panel Replacement - Right Side (LHD) (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair) .
6. Install the glove box assembly. Refer to Instrument Panel Compartment Replacement (LHD) (See: Body and Frame/Interior Moulding /
Trim/Glove Compartment/Service and Repair) .