G8 V6-3.6L (2008)
10. Remove the front caster arm to subframe retaining nut (4) and bolt (2).
Discard the bolts and nuts.
Important: The front caster arm to subframe offset washers (1) are used to adjust the caster of the front suspension.
11. Adjust the caster to specification by selecting and installing the correct front caster arm to subframe offset washer (1). For caster specifications,
Refer to Wheel Alignment Specifications (See: Specifications) .
12. Install the subframe offset washer to subframe retaining clips (3).
13. Install the NEW lower caster arm to the subframe retaining bolt (2).
14. Install the NEW lower caster arm to the subframe retaining nut (4).
Do not fully tighten at this stage.
Notice: Refer to Fastener Notice (See: Service Precautions/Vehicle Damage Warnings/Fastener Notice) .
15. Tighten the front caster arm to subframe retaining nut (4).
Tighten the nut to 50 N.m+ 120° (30 lb ft + 120°).
