G8 V6-3.6L (2008)
2. Connect the ECM electrical connectors (2) and lock the connector lock levers (1) into place.
3. Connect the battery negative cable to the battery. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and
Charging/Battery/Battery Cable/Service and Repair) Battery Negative Cable Disconnection and Connection.
4. Install the radiator air baffle and deflector. Refer to Radiator Air Upper Baffle and Deflector Replacement (See: Engine, Cooling and
Exhaust/Cooling System/Radiator/Service and Repair) Radiator Air Upper Baffle and Deflector Replacement.
Important: If the ECM is replaced it is required to update the remaining engine oil life. If the replacement module is not programmed
with the remaining engine oil life, the engine oil life will default to 100%. If the replacement module is not programmed with the
remaining engine oil life, the engine oil will need to be changed at 5000 km (3,000 mi) from the last engine oil change.
5. Program the ECM. Refer to Engine Control Module Programming and Setup (See: Testing and Inspection/Programming and Relearning) Engine
Control Module Programming and Setup.
6. If you encounter an ECM programming error, with a display message of "Starting Disabled, Remove Key" on the driver information centre, with a
diagnostic test code (DTC) of P1631, perform the "10-Minute Relearn Procedure" found in Programming Theft Deterrent Control Module
Programming and Setup. Refer to Theft Deterrent Control Module Programming and Setup (See: Testing and Inspection/Programming and
Relearning) Theft Deterrent Control Module Programming and Setup.
7. Turn OFF the ignition for at least 5 seconds after the programming event is complete.
8. Perform the throttle learn procedure. Refer to Throttle Learn (See: Computers and Control Systems/Testing and Inspection/Component Tests and
General Diagnostics/Throttle Learn) Idle Learn.
9. Use the scan tool to clear all DTCs.