G8 V6-3.6L (2008)
1. Install new O-ring seals (4-5) to the 1-2 shift solenoid (7), if the O-rings were previously removed.
2. Install the 1-2 shift solenoid (7) into the control valve body.
3. Install the 1-2 shift solenoid retainer into the control valve body.
4. Connect the electrical wiring harness connector (2) to the 1-2 shift solenoid (1).
5. Install the transmission fluid pan. Refer to Automatic Transmission Fluid and Filter Replacement (See: Automatic
Transmission/Transaxle/Service and Repair/Removal and Replacement) .
Important: It is recommended that transmission adaptive pressure (TAP) information be reset.
Resetting the TAP values using a scan tool will erase all learned values in all cells. As a result, The ECM or TCM will need to relearn
TAP values. Transmission performance may be affected as new TAP values are learned.
6. Reset the TAP values. Refer to Transmission Adaptive Functions (See: Automatic Transmission/Transaxle/Description and
Operation/5L40-E/5L50-E - Automatic Transmission/Transmission Adaptive Functions) .
2-3 Shift Solenoid Valve Replacement
2-3 Shift Solenoid Valve Replacement
Removal Procedure
1. Remove the transmission fluid pan. Refer to Automatic Transmission Fluid and Filter Replacement (See: Automatic
Transmission/Transaxle/Service and Repair/Removal and Replacement) .