G8 V6-3.6L (2008)
Transmission Mount: Testing and Inspection
6L50/6L80/6L90 Transmission Mount Inspection
Transmission Mount Inspection
Non Registered Notice: Refer To PSD SIE TITLE Error: SIE linked to empty Cell ID 120919
1. Raise the transmission in order to remove the weight from the transmission mount and create slight tension in the rubber.
2. Observe the transmission mount while raising the transmission. Replace the transmission mount if the transmission mount exhibits any of the
following conditions:
Important: Black paint on the rubber will crack with time, this does no constitute a failure.
*
The hard rubber surface is covered with heat check cracks.
*
The rubber is separated from the metal plate of the transmission mount.
*
The rubber is split through the centre of the transmission mount.
3. If there is movement between the metal plate of the transmission mount and its attaching points, lower the transmission on to the transmission
mount. Tighten the bolts or nuts attaching the transmission mount to the frame or transmission mount bracket.